Discussion Locked

Burnt Cd Not recognised

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am having trouble with some burnt cd's. When a programme asks for disk no 2 etc and I have put it in the drive the programme keeps asking for it as if I havn't put it in.
This is happening consistently.I burn at the lowest speed and have tried different brands of cd's.I was wondering if I have to use a different setting. I am a recent computer user and don't understand a lot of the terms the burner programme uses.I have asked Nero for help but they don't want to know. I am using windows 98.

11 replies

by csmith

This problem is going to require you to do some trouble shooting, because it can have several causes. They range from setup errors to bad CD-Rs.
Some CD writers have small buffers and can not stand to be on the same IDE channel (Cable) with the C: hard drive.
Check that there are two IDE cables (Flat , 40 conductor (40 Wires) cable.) going from the motherboard. One to the hard drive and the other to to the CD burner.
The usual warning signal for this problem is a message about buffer underrun, when the burn is finished.

Try closing all of the other programs running except the CD maker program, then burn a CD.

If these two tests do not work, the next most likely problem is the burner itself. (Warranty time.)
Regards, Chris

by gdunc65

Are you trying to copy disks? What program is the disks? What method are you trying to record? (from the hard drive or the CD-Rom).
What type of disks are you using CDR or CDRW?

by kender_girl

I've run in to this problem at work before with PC's that have older model CD-ROM drives in them. If your CD-ROM can read an "original" CD and other CD-ROM's can read the CD's you're burning, then it may be time to get a newer CD-ROM drive.

GoodLuck
Christina

by davemurgatroyd

From the sound of your query you are copying CDs which are "copy protected" - these will not copy with "normal" CD recording software although you may be able to copy them with a programme such as "CloneCD" which can copy "raw" CD data.

by thedrummer2006

It sounds like the program your trying to copy is copy protected. If the cd ran through the burning process thourghly with no errors try to open the disk with windows explorer and look at the files on the disk.
If the files on the disk are comparable to the original then it is probably copy protected. Alot of companies are using stupid little schemes to keep you from copying their disks. They loose money for every program that is copied. =)
They can hide a packet of data on a disk that your cd burner will not duplicate,Or some of them read the serial number on the cd which is hard coded into each cd. And other companies are using Colossable files which are files created to take up space so that a burner will not burn it. A CD contains 650 or 700 mb of data they can make one of these files appear to be 2 gigs and the burner will spit your blank out at you and ask for a larger cd.

You will need a program that makes 1 to 1 copies of cd's such as Clone CD.

Good Luck

This discussion is closed to new replies.