Question Locked

Can anybody help me

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a pentium 1 computer system.I formatted the Hard disk.Having done this, i tried to re-load win98 back into it.It always complain that I should insert bootable diskett.I made a bootable diskett from a friend and inserted it. It is the same problem and the floppy diskett light is always on, whether I have diskett inside the floppy drive or not.
could anybody help me with this problem.

6 replies

by toivo talikka

You do not have to have a bootable diskette to install Windows 98.

I assume that you are booting from the Windows 98 installation CD all right. The setup prompts you at one stage during the installation to create a bootable diskette, and all you need is a blank write-enabled diskette. However, it is not necessary to create this diskette, even though it is good to have.

It is likely that either the diskette or the floppy drive are playing up. It is not uncommon for the floppy drive to get out of alignment, therefore the problem may be either in your friend's PC or your own PC.

by computacentre

The problem is that because you dont have bootable cd rom iprogrammed into the bios of a pentium 1 computer. Your a:\ is broken as this is caused by a worn resister on the circuit board.Get a new floppy drive.

by itrfguy

Sounds like computacentre has the right idea. Given the age of the machine, a bad floppy drive is totally possible, and the BIOS has to be told that you want to boot from the CD ROM. On start up, most machines will display "To enter setup, press F2" or something to that effect. Once you're into the setup, tab through the options until you find one that allows you to select your boot device order. You'll see that your CD ROM isn't selected. Select it and put it as your first bootable device. Save this configuration and reboot with the Win98 CD in the drive. Give this BIOS fix a shot and get back with us.

by charliespencer

If it's been a while since you used the floppy drive, it may be dirty. You can get a cheap drive cleaning kit for a couple of dollars.

Have you tried booting from the Windows 98 CD? It's been a while since I installed 98, so I don't remember if the CD is bootable.

by garylash

Floppy light always on is a commonlly known error. the data cable is inserted backwards on either the drive itself or the MB . Hope this helps.

This discussion is closed to new replies.