Discussion Locked

Can I add a 5th ide drive?

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How can I add a CD-Rw drive when I already have 2 hard drives, 1 iomega pc100 zip drive, and I cd drive? Can you help?

13 replies

by eoin.farrell

your best bet, if you havent bought the cd-rw would be to buy a SCSI interfaced cd-rw, purchase a scsi pci card and attach both.

hope this is of some help,

Eoin.

by joe prochazka

You can buy yourself a PCI IDE controller which you can plug into a PCI slot on your motherboard. Promise Technologies (http://www.promise.com/) Makes excelent IDE controller cards. Also by going with a new controller card you will ba able to take advantage of UltraDMA 66/100 Hard Drives which can offer you anywhere from a 66mb to 100mb a sec transfer speed from your hard drive to your computer.

You will find it a heck of alot cheaper then buying a scsi controller and scsi drive.

I am running 4 IDE channel which is able to run 8 drives in all on my machine.

by dmiles

If you use the EIDE,you will be able to connect up to eight drives internally using the EIDE cable.
If any of the drives are external you will be better off using a SCSI adapter card.

by thayer

Some sound cards support an IDE, I have used this to connect my CD Rom, install the IDE software supplied with the card. This will free up your main board IDE's, but be sure to install the software for dos or else you loose the use of the CD Rom while in Dos. Your existing sound card my already support this and you will not have to invest anymore money on any extra hardware.

by b_chapel

Another option for you might be to purchase one of abit's system board's. Several of them have 4 IDE chanels built on the board, Two are used for ata/66 and above dirives, and the other two can be used for ata/33 and below. All the IDE ports will work with any type of IDE drive but follow recommendations by manufacture for best results. Check their web page for more detail. www.abit-usa.com
Good luck.

by hiltont

Hi,

Originally, IDE-supporting motherboards came with 2 channels that could support 2 drives each. Primary Master + Primary Slave and Secondary Master + Secondary Slave = 4 drives. The next series of boards supported the EIDE protocol (an improvement over the original IDE), but this interface is still limited to 2 drives per channel.

Some newer motherboards have 4 IDE channels on board, such as some of the Abit motherboards. These boards support 8 drives (and use only one additional IRQ).

Your best option right now is to purchase a Promise (or similar) PCI-EIDE card and add the new drive to this interface.

(Actually, if both of your hard drives are the same, your best option is to purchase an ATA-RAID (or EIDE-RAID) controller and connect a hard drive to each channel as master, reformat and reinstall, and watch your system fly!)

Another option is to purchase a cheap(ish) SCSI controller (Adaptec, Initio, Tekram, etc) and purchase a SCSI burner. This option will be more expensive than the EIDE card option above, but will provide a SCSI interface for your computer should you wish to add other SCSI devices (such as a scanner).

Regards,
Hilton

This discussion is closed to new replies.