Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Whew, Long question. I have 2 sata hard drives, no ide hard drives. Since I have 2 ide plugs on my MB can I plug each DVD into it's own IDE plug? If so, would I set them both as masters? I'm a little afraid to try it.
3 replies
by kirk227 Accepted solution
Clarifications
by mjworsdale Accepted solution
I have 2 sata's and 1 ide hdd set as slave and 1 dvdrw set as master and all is well. I'de set the dvd's you have to master and slave.
by oh smeg Accepted solution
You can use 2 Optical IDE Drives ands Yes you can connect each to it's own IDE Lead and set them to Master.
Though if the M'Board supports this you need to connect the Optical Drives to the right IDE Connection generally the end of the IDE Lead and everything should work without a problem.
Just look at the IDE Leads that you are using and see if there is anything special needed by the markings on them. These should be the latest 80 Way IDE Cables and not the slower 40 wire Cables that where used a while ago.
Col
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies