Discussion Locked

Cannot find manufacturer?

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

How do I get a scanner to work when I cannot find support from the manufacturer or retailer? I recently bought a scanner at a swap meet. ImageReader Express by Info Peripherals.

I get the error message "cannot find scanner" or "The procedure entry point SMapLS could not be located in teh dynamic link library KERNEL32.dll"

Do you know of someone with this type scanner or has gotten past such errors with other scanners. DO I need a SCSI card?

4 replies

by ise_bahamiam

I neglected to inform that I am using Windows 98 and 192 MB RAM and 11GB free hard disk space. I also have installed and uninstalled the hardware (scanner) and scanner software countless times now.

by shiny_topadm

Hi,
When you say "swap meet", I hope that means that you did not pay much for that device! The manufacturer went out of business in 1999, although many products were still sold ("new") thru various outlets for about another year. There is a site were a former employee has some drivers and manuals posted, http://www.stimpco.com/info/
maybe that will help. I would certainly start with installation procedures from the manual and correct drivers, because any of these (that I've seen) were NOT "plug-n-play". Your problem could be as simple as an improperly configured parallel port and/or cable (assuming that's how it connects), but I know they did produce some models that used their own "card" for the communications interface. Good luck...

---Will

This discussion is closed to new replies.