Discussion Locked

Cannot Find Out the Hard Drive In Win98

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Would anyone tell me why my 2GB
harddisk cannot be detected by Win98.
However, it can be identified by my
motherboard in bios?

I have changed the jumper to slave
because I have a new 30GB harddisk. I
use the first primary IDE to connect two
harddisk, one is 30GB for master and
other one is 2GB for slave. Then I use
second primary IDE to connect a CD-
ROM.
Thank You.

9 replies

by dmiles

Recheck the Bios settings to see if the drive is set to AUTO in configuration
Open the control panel and select the System icon,under device manager see if the drive is listed in the drop down list of hard disk.
Recheck the cable to make sure it is connected properly and also the jumper settings.

by dr. dale

If the hard drive is detected in the BIOS, it's not a cabling or jumper issue. Does the 2GB drive have a file system that WIN98 can recognize? If not, you will will have to reformat the drive. Use Partition Magic if you need to save the data on thatdrive.

by bruce d.

Follow Soulrider's suggestions, also check jumpers on the 30GB drive. Most new drives require different settings if they are the only drive or if they are Master with Slave.
There is another issue. Intel has an "Ultra ATA Driver" program. We have found that this program can hide non-ATA drives from Win98/ME if installed.
Also be sure the DMA box in Device Manager settings for the 2GB drive is NOT checked.

This discussion is closed to new replies.