Discussion Locked

Canon BJ S450 doesn't print the color bl

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Printer will not print any black text. Have checked cartridge levels/operation and performed print head alignment/cleaning and nozzle checks. All three color cartidges function fine. Black printed fine until about a week ago. Ink level appears okay. Any feedback appreciated. Thank you, rlb1956

10 replies

by thechas

I assume that when you print a nozzel check and self test page that you also have no black.

Have you been using ink refill kits?

I have seen many a print head clog up when using some refill kits, or even off-brand ink tanks.

I havn't workedon a S450.
Can you easily remove the printhead?
If so, look at the surface of the printhead.
If it is all gummed up, you may need a new printhead.

Looking at the Canon manual, you replace the BC-30e cartridge (ink tank and print head) to replace the print head.

You can try just removing and reseating the BC-30e cartridge. Make sure that ink has not leaked onto the contacts for the cartridge.

I need to re-seat the cartridges in my Canon 7000 every once in a while. I suspect that the electrical connections are not 'gas' tight, and oxidize over time causing a bad connection.

Chas

by mallardtooxx

Check your print head, It could be loose. There is also the possibility of a totally clogged black print nozzle, this happens when you use off market refills or refill kits. You have to make sure that all of your connections are in place too, Cannons are notorious for losing connectivity internally. You may also try changing out the black cart. It could be defective

by mallardtooxx

Check your print head, It could be loose. There is also the possibility of a totally clogged black print nozzle, this happens when you use off market refills or refill kits. You have to make sure that all of your connections are in place too, Cannons are notorious for losing connectivity internally. You may also try changing out the black cart. It could be defective

by mallardtooxx

Check your print head, It could be loose. There is also the possibility of a totally clogged black print nozzle, this happens when you use off market refills or refill kits. You have to make sure that all of your connections are in place too, Cannons are notorious for losing connectivity internally. You may also try changing out the black cart. It could be defective

This discussion is closed to new replies.