Discussion Locked

Can't Defrag or Scandisk?

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Running WinMe...can't perform a Defrag or run a Scandisk? System also freezes to a black screen on occassion (becoming frequent)? Virus definitions may not be completely updated...maybe this is a virus?

14 replies

by dmiles

Try narrowing it down by running anti-virus software on the drive,once this is complete,you can boot from the startup disk and run scandisk from the DOS prompt,if you have anti-virus ERD disk you can boot with it and run anti-virus.

To run scan disk and defrag from Windows,disable the anti-virus and power management then run the utilities

by 1stladytech

Most of the time defrag and scandisk will not complete at the real mode desktop. I agree that you need to check you anti-virus defs, get them updated and then reboot the machine in safe mode. Run a virus scan and then a scandisk and defrag after that. Too many programs running at the realmode desktop cause problems, the biggest one that I have found is FindFast - you will never get either to complete with this active.

Vickie

by djent

With ME if the restore function is enabled it may consume large amounts of space and prevent defrag from working, disable restore.

by learn4ever

This seems like a obvious check, but is there enough free space on the drive for defrag to perform? A minimum amount of free space is required or defrag will not run. The free space reported by Window Explorer in WinME can be deceiving too....your swap file and space used by system restore aren't usually shown in this figure. Try opening a DOS window and checking the amonut of disk free space that way.

by hb_bc

Try running ScanDisk in DOS. Restart in DOS and type SCANDISK C: and let it run. Also do a surface scan when it prompts you. It may a few hours to run depending on the size of your hard drive.

by deadly ernest

As already stated the system needs 15% of the drive to run defrag properly, some cases it will refuse to run, other lock up. You can return space to your system by resetting the sapce used by the 'Recycle Bin' and the 'Restore' function. The defaultsetting are 10% of each drive for the Recycle Bin and arouns 8% of each drive for the Restore. Access ing the Propeties setting of the Recycle Bin will allow you to reset this to 1% (empty it first), and the Restore settings can also be lowered or turned off from the 'System' icon in the Control Panel

This discussion is closed to new replies.