Discussion Locked

Can't get my modem to answer

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm trying to set up a Hayes Accura 56k speakerphone modem to answer calls when attached to remote download equipment. (For the sake of argument this could be taken to be a dumb terminal using RX/TX/GND cabling.)
I can set up the modem to answer when connected to a laptop running terminal emulation with full modem cable but it won't answer when connected to the equipment mentioned first. I suspect this is due to an RI signal on the cable which in my case is obviously not being used.
Is there anyway to overcome the problem by hardwiring pins or using AT commands to change the answer options on the modem? Answer mode is already enabled and baud rate is appropriatlely set.

5 replies

by richard_barsby

Hi I don't know if this is your problem but when only using 3 wires the hand shaking is done by software using XON/XOFF settings I don't know how to apply this to modem use though, I hope this leads to your solution.

Best Regards

R.K.Barsby

by actech

Richard, Thanks for your reply. I assumed xon-xoff is being used and I think the modem is waiting for some signal back from the terminal device to tell it to pick up the line. Does anyone know how the RI line works as I have a feeling this may be involved? Or can anyone advise how to set the modem to answer with no interaction with the terminal?
Older modems could I think be set to answer with nothing connected but I'm unsure how to configure a modern modem to do this.

by rawright

ATS0=n
AT&W

These commands will set Status Register 0 to 'n' rings before answering the incoming call, then save this setup as the default. If S0 is set to '0', the modem will not answer. You can program the modem from your dumb terminal, or the laptop with the modem connected. Type +++ to get the modem's attention, then type AT . If the electrical connection is good, you should get a response of 'OK' from the modem. Then enter the two commands above with 1 or 2 replacing 'n' to set the modem up to answer the phone. If this doesn't work, email me and we'll try some other AT commands that are sometimes required (rare).

by actech

I set the AT commands to auto answer but it still wasn't picking up on the dumb terminal. Picked up ok on a laptop with term emulation though. I found the problem to be due to hardware handshaking - connecting DTR/DSR together allowed the modemto answer.

This discussion is closed to new replies.