Discussion Locked

can't install swappable cdrom drive

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hi I am Eric.I own a gateway 200 120mhz 3pc laptop.Which has a swappable cdrom+ floppy . I can not get the cdrom installed.because the bios config setup has no information on cdrom.there is:- boot to h/drive and boot to floppy.There is no ,boot to cdrom.And I can not get it to change And I need to install win 98 .. some one told me to edit the config line in .Edit .com I dont know about these things yet. and I love this little laptop I will like to keep.I need someone to walk me through the steps step by step.Please help me.Eric

3 replies

by cartoon

You must edit both your autoexec.bat file and your config.sys file.
In your autoexec.bat must be the line or similar
"C:\WINDOWS\Command\MSCDEX.EXE /D:MSCD001"
Without the quotes
Your Config.sys file should have the line (to point to your driver
"C:\WINDOWS\VIDE-CDD.SYS /D:MSCD001"
(VIDE-CDD.SYS is your manufacturer driver. It could be anything, but see if it works)
Hope this helps you
carterbe@optusnet.com.au

by deadly ernest

Hi Eric,

here is the generic back up plan to load your Win98, but first you have to get a Win98 Boot Floppy Disc (ask a friend to make one for you).

You place the Win98 Boot floppy in the system and boot from the floppy, this will load a cut down version of DOS. In the boot process it will ask you if you want to load with CD-ROM support or not, select the CD-ROM support option; this will then detect and load generic CD-ROM drivers into the virtual drive it creates in the RAM.

Once the system is bootd into DOS you can use standard DOS commands to go to the CD and start your Win98 load. However, since the Win98 disc usually expects to be activated from a previous Windows or as a boot CD you have to navigate to the file and run it.
The file that you need to run is (assuming that your CD-ROM is drive E: - which is usually the case, C: for the HDD. D: for the virtual drive);

E:\SETUP.EXE

NB: if you have an upgrade disc this may not work as some of those a set to run fromwithin a Windows environment only.

BTW if you have a similar problem with Win NT, W2K or WinXP in the future, the same process will work except that the file to run is:

E:\I386\WINNT.EXE

Good luck

by tech12345

You can find the original setup discs for Gateway 2000 for sale on E-Bay. They will walk you thru the process of formatting the hard drive, installing CD-ROM drivers, and preparing for installation of Operating System from your Win98 CD.

This discussion is closed to new replies.