Discussion Locked

Can't permanently change drive letters.

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Windows XP Pro system whth four hard drive partitions and a CD-ROM. The partitions used to be lettered as shown below.

Pri Master ? 1 Dynamic volume ? C:
Pri Slave ? 2 Dynamic volumes ? Z: and D:
Sec Master ? CD-ROM ? F:
Sec Slave ?1 Basic partition ? E:

One day, the BIOS reset itself for unexplained reasons. since then, the CD_ROM has taken the D: drive letter and the partition that was the D: is forced to F:. I can go into the drive manager and change them back, but, that only lasts until the system is rebooted. If I disable the CD, and set volume 2 on the Pri Slave drive to D:, it will hold that letter through many reboots. As soon as I enable the CD and reboot, it takes the D: again. I found nothing unusual about the current BIOS settings.

I played musical drives so it now is configured like this:

Pri Master ? 1 Dynamic volume ? C:
Pri Slave ? 1 Basic partition ? E:
Sec Master ? 2 Dynamic volumes ? Z: and F:
Sec Slave ? CD-ROM ? D:

I even tried two different CD drives with no luck. I reflashed the bios - no luck. Does anybody know how I can get back to my original drive letter assignments? I have most of my programs installed to the D: partition so I don't want to just use that partition as F:. By the way, the motherboard is a ECS K7S5A with the latest bios.

4 replies

by opatzg9

I have windows 98 and haven't seen xp yet but the control panel/device manager/cdrom driveicon/properties/settings sets it in 98. So am I correct in understanding you have used the device manager xp version to define the cdrom start and end letters the same as F:? and then it resets itself? Otherwise try resetting it there.
Good Luck

by steve.custer

Thanks for answering. In Win 2000 and XP, the settings you spoke of are not available in the device manager. The only place I know of to change the drive letters is in the computer management console.

by thechas

Check for a DOS mode driver for the CD drive.

This could be in any of the startup files, but is most likely to be in autoecex.bat or config.sys

For XP, this may be boot.ini

You should be able to uncheck the dos driver from the startup tab of MSConfig.

The DOS CD-ROM driver statement can be set to assign a specific letter to the CD drive, which is why I suspect that to be the problem.

Chas

by steve.custer

Thanks for answering. I did not find any DOS drivers. I did discover that if I set the drive letters to what I want them to be then boot under Safe Mode, the letters did not change. However, if I use MSConfig and select Diagnostic Startup, the letters are changed after reboot. Windows is making the switch, not the bios.

This discussion is closed to new replies.