Discussion Locked

Can't recognize Hard Drive

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have replaced many hard drives but this one has me stumped. I replaced the hard drive but now the bios won't recogize the new hard drive it says none. It will find a cd rom. I have tried different cables and different IDE plugs. I have tried 2 hard drives that I know work in other Computers. I have even replaced the motherboard and still it says none. Please help.

11 replies

by tjc

What happened when you tried the 2 hard drives that you knew worked - did it work in the this system? If so then you may have shorted out the one drive that doesn't work. I'm sure you did the usual of checking the cables and such.

What about trying the "bad" drive in another comtpuer to make sure that it gets auto-recongized correctly

by tjc

So we know now that it is not the hard drive. Question. What is the size of the drive. May be the cmos doesn't reconize drives over a certian size?

When you say it says "none" do you mean when you go and auto detect it in cmos? What about typing in the cylandras (sp) and heads by hand?

by csmith

The symptoms that you describe are usually certain Fujitsu drives, paired with certain BIOSs.
Try jumpering the Master for Master With Slave Present, and then put in an old (300MByte) Slave.
This works sometimes. Have done it.
WARNING!!!
This also can kill the transfer rate on IDE channel 0 with some BIOSs. (The transfer rate defaults to the slow 300 MByte drive.)
Regards, Chris

by mike (from canada)

your cmos could be old and there might be a limit to the hard drive size. try the floppy disk that came with your hard drive. It might have a driver that activates the hard drive. If everything fails, then your hard drive is corrupted and u need to replace it.

by adnova2000

Ive seen this problem w/ drives that people have used EZ-BIOS on. If the drive was bad, the sys would still recognize it. You should go to the website and dload a current BIOS for the machine. I would definitly try the previous suggestions. Make sure the Cable to the HDD is in IDE 0/1, whichever is 1st, disconnect anything on the other IDE, check the BIOS to make sure IDE 0/1 is enabled. In other words, start over. Im sure you've done this, but I would start there. You can see the CD-ROM, so asIve said, check your IDE conn's and if they are enabled in BIOS.
Armand.

This discussion is closed to new replies.