Discussion Locked

Cat 5 4-pair cable vs Cat 5 2-pair cable

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Beldon has UTP and STP Cat 5 cable in PVC jacketed and plenum jacketed and in 2 pair or 4 pair versions.

Only 100Base-T4 requires all 4 pairs; therefore, a 2 pair Cat. 5 cable should be able to be use on all 10/100base-T straight through and crossover applications; except for 100Base-T4.

During the cabling a 100Base-T connection between a Cisco 4006 Switch to a Lucent Hub, a tech used a 4 pair cable but only attached two pairs; i.e., conn#1:Pr #1 to p1&p2, Pr #2 to p3&p6; conn#2:Pr #1 top3&p6, Pr#2 to p1&p2.

The connection did not run error free; so, the tech recabled using all 4 pairs which produced an error free connection.

Can one conclude that all four pairs are required or that the first cable was made poorly?

(Pls note that the connection was assumed to be 10Base-T until after the equipment was tested and found to be atempting an 100Base-T connections.)

If the connection was made using a 2 pair cable, which was made correctly of course, is there any reason why the equipment could not maintain a 100Base-T connection?

6 replies

by wanabedrsean

sorry. the only reason I can think of is that the cables were not wired properly alot of people think that if both ends are wired with the same pin outs it will work, and it will for about twenty feet with low noise but the signal wires have to be180 degrees out of phase so they all have the same noise on them and the recieve and transmit pairs are also 180 degrees out of phase.

by bigduck

CAT 5 only uses two pair regardless of if the speed is 10 or 100 Mbit. The other 2 pair in the wire are used only to help maintain a ground connection. If it did not work the first time, then chances are that the cable connection was imperfect.
According to the CAT5 IEEE spec you only need 2 pair. I have run numerous 100 Mbit workstations using only 2 pair on the CAT5 cable completly error free so I know it can be done.
In most hubs--if you take them apart and look at the circuit boards--you will find that only 4 of the 8 connections even have traces.

This discussion is closed to new replies.