Discussion Locked

Cat cable

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Ok, dumb question. What is the difference between cat-5 and cat-6 cable?

Thanks in advance.

ken

11 replies

by oz_media

Cat5 offers ample throughput for 10-100 networking.

CAT6 is designed for greater throughput, mainly only see a difference in VoIP or videoconferencing across a network.

Your are probably limited by your Inetnet provider, in which case Cat 5 or Cat-5e (same as Cat6) will give you enough throughput and Cat6 won't make any difference.

The difference is whether the copper pairs are twisted or stright, neither will effct you from a home connection, ADSL or Cable. However, yourlocal PC retailer will probably be convinced that Cat6 will speed things up for you, it is also more expensive.

by thechas

Both Cat 5 and Cat 6 cables use twisted pairs.

Cat 6 uses 23 AWG wire versus 24 AWG for Cat 5.

If memory serves me correctly, Cat 6 has more turns per foot, and a tighter tolerance on the twisting.

If you are installing new wire, it may be worth it to install Cat 6 to allow for future growth.

Keep in mind, that any network is limited by the speed of it's slowest component.
If your router and NICs are all 10/100 there is no performance improvement for using Cat 6 over Cat 5.

Chas

by oldefar

Thought I would add my comments on wiring in general.

The station wiring is in fact a circuit. The number of twists per pair impacts the inductance, the insulation on individual wires creates a capacitance, the gauge of wire and stranded or solid copper wire defines resistance. As a result, the wiring becomes a filter as well as a conductor.

As you move up in frequency, the inductance in particular has a greater impact on performance. This is why maintaining the twists as close to the connector as possible becomes critical.

Straight wire may be easier to connect, but straightening twisted pairs at the connection defeats the engineering behind the cable selection.

No impact? In 1985, IBM was trying to demonstrate their 16 Mbps token ring over twisted pair to GM Research. After several weeks of failure, they finally asked the wire pullers (part of my crew) for assistance. I simply replaced the flat station cables they had stolen from us with data station cables - twisted pairs - and their system finally worked. :)

by csmith

Oldefar forgot to mention that the twists prevent noise pickup.
Tightly twisted cable can perform as well as shielded.
Maintaining the twist is critical, and this applies to the connector as well, or you will get "Near End Crosstalk."
Cat 6 is about the limit.
For faster stuff, it is fiber optic time.
Regards, Chris

by dplewis

Not much to add to previous, vey good answers, except that even Cat 5 also offers Gigabit ethernet support (1000BaseT) but, unlike 10 or 100 it uses all the pairs. This catches out scrimpers who didn't perform a full Cat 5 installation. Note also there is such a thing as Cat 5e (enhanced Cat5) which falls somewhere between the two as regards "quality". PS> The previous mention of VoIP working better over Cat 6 is, I would say, a bit misleading. VoIP might, in theory, be slightly more susceptible to dodgy cabling as there's no chance of packet re-transmission however, if cabling is causing VoIP drop-outs, it will be affecting more traditional data streams too.

This discussion is closed to new replies.