Cat5 cabling
In cat5 cabling only 2 pairs are used to transmit & receive data. i.e. RC+ RC- Tx+ Tx-
another two pair is left over , what is the function of those two pair ??
Hardware
In cat5 cabling only 2 pairs are used to transmit & receive data. i.e. RC+ RC- Tx+ Tx-
another two pair is left over , what is the function of those two pair ??
It's for other use, remember that Cat 5 is a standart and is not exclusively for computers.
For example in cat6, all the pairs are used (grouped in pairs), as a trunk in order to deliver 1GB.
by k4k
by bigduck
The other two pair are for future use. The standards are always being revised and in this case they are simply looking to the future and makeing sure they will have the capacity to use the extra wires if anyone ever comes up with a good reason to use them.
You do not even have to connect the other two pair to make the connection work. In fact may devices, shuch as hubs and low end network cards do not even have any traces on the circuit bords for the other wires to even go to ground. They are simply dead ends.
by k4k
by k4k
This discussion is closed to new replies.
Sort by Trending