Discussion Locked

CD/ CDRW not both detected at start up

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

CD Rom and CD RW not both detected at startup
If both connected on same ide cable not one detected, if you disconnect one on connect at end of cable cd detected

5 replies

by djent

Do you have both drives defined as master or slave or one of each? Check the jumpers, set one as master the other as slave.

by thechas

In addition to making sure the jumpers are properly set to master and slave, make sure that you are not using a 'cable-select' style cable.

These usually have a hole in the cable near one of the drive connectors.

Chas

This discussion is closed to new replies.