Hardware

Ask something
Discussion Locked

CD drive reset?

0 helpful
5 replies

by lmoore

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
After dopying a cd from my cd reader to my burner using Nero 5.0 I find that the next time I put a cd in the reader it has trouble reading the next CD.It will read it after 3 or 4 minutes of trying, or even rebooting the machine each time.Is there acommand that would reset the drive after each use?

5 replies

by b_pope

Check Nero's settings, sounds like you left the previous burnt CD open in Nero rather than closing that session when you ejected it. Which would cause Nero a little confussion as it's looking for the CD you already took out.

by still_learning

I have a question for you. Are you certain that you had successfully burned that last CDRom? I ran into a similar problem, but it seemed that the problem was the blanks that I was using, rather then the hardware or software. Sometimes you get bad blanks. Try another brand. Hope this helps.

This discussion is closed to new replies.