Discussion Locked

CD not accesible device is not ready

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My pc can see the drive but errors not accessable drive not ready when clicked on.
It is a wearness cdd-620
On the web site it has firm ware update but when I tried using it it had no exe file and it failed. It took unplugging the PC and many hours to get the pc to boot again. It would only boot in dos and said waiting to load dos program. It seems like this was only for a dos driver. I use win 98. In device manager it says no driver files are required or loaded for this device. When I click update it shows a mscdrom.inf file. ...help
jan

7 replies

by opatzg9

Hi Jan,
Was the file you downloaded ending in .zip? If it was then you need to uncompress the file with winzip a utility you can download from most anywhere, check zdnet.com for locations. After uncompressing in a folder run the exe found there.
If there was no .exe, if there was a .inf then that is the driver update, goto device manager, select the cdrom drive, update driver. Good Luck!

by cyberjan

da, the files are dll files and readme says they are good only for win 95
the firmware are sys files and crashed my computer

by thechas

Normally, for firmware upgrades, you need to copy the files onto a DOS boot disk.
Boot from the floppy, and run the correct sequence of commands to install the firmware.

Firmware for a drive is similar to the BIOS on your motherboard.

Now, 'usually' problems with CD drives under Windows are caused by missing or corrupt IDE drivers for the chipset on the motherboard.

I always install the chipset mfgs IDE drivers for any motherboard that I setup.
If this is a name brand system, start with the mfgs web site.
Otherwise, go to the motherboard mfgs web site.

If you cannot identify the motherboard, check out the tools at either www.motherboards.org
or www.wimsbios.com

Chas

by cyberjan

I think this is just a really old cd drive which is unsupported under win 98. I went to gateway and it only had drivers for dos or win 3.1
I put in an old cd rom game and sure enough it read the disk. Could it just not be able to read newer fast cds.

by thechas

Many older Cd drives cannot read CD-RW disks, and can have problems with CD-R disks.

Further, it could have problems with CDs with more than the 'standard' 650MB on them.

It is not the 'speed' of the disks that gives the older drive problems, it is the data density, and structure.

Chas

This discussion is closed to new replies.