7 replies
by ann777
If the data cd is not "closed" (ie... if it can still accept more data), then some driver will not recognize those cd's. Close out the writing of more information, then test the cd in that drive.
by hhchua
by bigduck
I had the exact same problem on one of my machines,and the only way I could solve it was to change the jumper on the back of the drive to the CS position.
Note that if you have another device on the same IDE channel you will also need to change its jumper to the the CS position.
by hhchua
by pontiac1
I too have seen this problem and the answer to it for me was to check the cables, after reseating them it worked fine.
Hope this is of some help.
by hhchua
by hhchua
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending