Discussion Locked

cd-rom drivers

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I can not configure my cd-rom. It a meccer 52x speed cd-rom. Is it possible for you to configure it on the web?

1 reply

by thechas

Not sure what you need.

If you are having problems with the drive in Windows, check the following;

1. Cable connected properly, and connectors seated.
2. Jumpers set properly on all drives on the same cable. (master / slave)
3. Enter CMOS/ BIOS setup at boot.
Make sure that the IDE controller, and IDE channel tha the CD drive is connected to are enabled.
Also, make sure that the specific drive location in standard setup is set to either auto-detect, or cdrom.
4. You may need to install / update the IDE bus master driver for your motherboard.
If you need help to find the drivers to download, check out www.motherboards.org
or www.driverguide.com

If you are having problems with DOS mode programs and the CD drive, then youmay need to install the DOS driver from the floppy that should have been with the drive.

Chas

This discussion is closed to new replies.