Discussion Locked

cd rom not showing

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Ok heres my problem my cd roms arent showing and when i go to device manager it shows a yellow asteriks beside the cd rom and says resistry may be corrupt, can anyone give any advice?

13 replies

by dmiles

Check the Win2K,compatibility list to see if it's listed and try downloading the drivers from the manufacturers web site,they may have updated drivers.
Also check to make sure you dont have any conflicts with other ports.

by buffalodan

I would physically remove both drives, and allow windows to start without the drives installed, check the registry again for corruption, if all is well then re-install the cdrw's one at a time,

at the very least, windows will see these drives asa standard multi speed cdrom drive,
without the use of additional driver software.

hope this sets you on the right path....

by buffalodan

P.S> I would also make sure that the software you are using for controlling the cdrw's is also correctly uninstalled when you remove the dirves.

As stated earlier, when a cdrw is installed into win2k, it will be viewed as a standard cdrom drive, and this should be verified for proper read access before proceeding with installation of your cdrw software....

by buffalodan

also,

make sure the software you are using to control these drives is win2k compatible as well....very important!!!

by erikbutler

just by chance did you install any adaptec software. If so the software can corrupt your apix.vxd and the aspienum.vxd in your devices.

by gdunc65

Perform the following steps to remove the filters. Be sure to export the registry before changing any registry settings.

Click on Start/Run. Type in regedit and click the OK button.
From the Registry Editor window, click on the Registry pull down menu and choose
Export Registry File. Save the file to the desktop.
Locate the following key in the registry: HKEY_LOCAL_MACHINE\SYSTEM\ControlSet
In some cases, there may be multiple ControlSets. You may see something similar to the following

HKEY_LOCAL_MACHINE\SYSTEM\ControlSet
HKEY_LOCAL_MACHINE\SYSTEM\ControlSet001
HKEY_LOCAL_MACHINE\SYSTEM\ControlSet002
Or
HKEY_LOCAL_MACHINE\SYSTEM\ControlSet001
HKEY_LOCAL_MACHINE\SYSTEM\ControlSet002
Choose either ControlSet or the lowest numbered ControlSet, for example, in the second list above, ControlSet001, and do the following.
Locate the following key and highlight it in the left window of the Registry Editor.
HKEY_LOCAL_MACHINE\SYSTEM\ControlSet\Control\Class\{4D36E965-E325-11CE-BFC1-08002BE10318}
In the right window, you should see something similar to the following. There may be some variation in the listed drivers.
You may also see only Upper or only Lower Filters
LowerFilters = CDR4_2K
UpperFilters = PWD_2K
Delete the Upper and/or Lower Filters.
Exit the Registry Editor and reboot the system
Once the filters are removed and the system is rebooted, the CD-ROM drives should all be recognized.

This discussion is closed to new replies.