Discussion Locked

CD-ROM Not Working

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a generic PC (not a name brand) which we installed Windows 98 on recently and now the CD-ROM will not work. Upon boot up, it appears to recognize the CD and there is a Mitsumi CD listed in the Devices list, but it does not show up in My Computer or Windows Explorer. I tried the update button to have the computer look for a new driver, but that did not work. I do not have any floppy disks for the CD-ROM. Any suggestions on how to get this thing to work?

9 replies

by thechas

You need the W98 drivers for the chipset on the motherboard.

Try the motherboard mfg web site, or identify the chipset, and download the drivers from the chip mfg.

If you need help identifying the MB / chipset, go to www.motherboards.org
Theyhave tools to help identify who made the board, and links to web sites for drivers and information.

Chas

by cbach1997

Open sysedit and look at your config.sys

Look for a device=***.sys /d:****

This is your cdrom device driver entry, which you apparently have since you said you can see it on bootup.

Edit autoexec.bat by adding a line with
c:\windows\command\mscdex.exe /d:****

It'll probably show up, but be in MS-DOS compatibility mode (slower performance). If it shows up in Windows, try taking the line out of autoexec and see if it still works after a reboot. If it does then you should be a full throttle.

Hope this helps, good luck
cbach1997@hotmail.com

by gigelul

If is an old CD-ROM disable in BIOS UDMA support for IDE channel where is installed your CD-ROM. Also in Windows (device manager\CD-ROM\properties)

by jeifert

Go to "start", "settings", "control panel", "system icon", and check under hard disk controlers. If a yellow exclamation point appears before your primary and secondary IDE controllers then windows failed to load the protected mode driver for your CD. To fix goto run, type regedit. This will allow you to edit the registry. On the "registry" drop down menu located on top of the regedit box, click export registry and save it as reg1.bku on your desk top.
Next follow this path: HKEY_LOCAL_MACHINE\system\currentcontrolset\services\VxD\IOS on the right pane you should see the NOIDE value. Click this value and delete it. Quit registry editor and reboot. You should see your CDrom in My computer now. If anything goes wrong, just run regedit, click on registry accross top and import from the desktop the reg1.bku that you saved earlier and try something else.

Good Luck!

This discussion is closed to new replies.