Discussion Locked

CD-ROM not working in Win98

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My CD-ROM drive was working fine in Win98
and it also picks up with DOS Drivers but for some reason its not showing in My Computer any More. I've tried everything. There also seems to be a problem with Primary and Secondary IDE Controllers.

Any reason why this happens?

11 replies

by dmiles

Go to Device Manager and check for any yellow marks on the cdrom or ide controllers.
Now highlight the CDrom and cick on properties and select the performance tab,if it running in MS Dos compatibility mode you will need to update the drivers.

by jctech

Most likely cause of this is a boot sector virus (Sampo.A is a good example). It makes changes to your hard drive's boot sector and renders your CD drive inaccessable, and will also show problem with both primary and secondary IDE controllers. Also, under performance tab in system properties, hard drives and floppy drive will be running in MS-DOS compatibility mode. The way to clean the virus is to boot to a clean floppy boot disk to insure the virus doesn't load into memory, then run a goodDOS based virus scan and clean utility with an up to date virus pattern to clean the virus out of the boot sector. Then remove the boot disk, reboot to windows and your CD drive should be restored.

by glittersapphire

I had that same problem and this is what worked for me. Put the startup disk in drive a if you have one for windows 98 and the windows 98 cd in the cd rom drive. Restart your computer and when the screen comes up choose start w/cd rom support. then next type e: and enter then type setup and this will reinstall windows 98 and that should fix the problem and it should begin working agian. I hope this helps!

by shanepri

Please do not do a dirty install of your OS especially with bangs in device manager! What chipset is the MB? If you upgraded your sys from win95 & have a intel PIIX4 ide controller, you MUST uninstall the PIIX4 before upgrading. If this is not the case, try removing the pci bus from device manager under sys devices, & rebooting. This will force the OS to reload all device drivers connected to said bus. Final option, fdisk format reinstall! I perfer the later.

by galamb

Try the Win 98 bootdisk and boot with cd support. If it sees your CD Rom then the problem is in windows. If it doesn't see it e-mail me or repost here and let me know. You can also attempt to intall the cd again in the control panel. Good luck.

electrojolt

This discussion is closed to new replies.