Discussion Locked

CD Rom Problems

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I know that I am overlooking something easy. I have a Gateway 333Mhz Win98 system that I am maintaining. The CD Rom began having difficulties reading disk after some minor troubleshooting I purchased a new CD Rom and installed it> No Problems at first. It is now having the same problems. I recieve error message related to device not found yet I hear the system spinning the drive. What have I missed.

7 replies

by ann777

The problem may be that the current cd-rom drive is just too fast for your hardware, that with use, the computer cannot handle the speed of it.

Make sure that your read the minimum specifications of the cd-rom drive and compare it to the hardware of your computer. Can your IDE/SCSI controller (which may be embedded on the systemboard) can handle the requirements of the cd-rom device you are purchasing? Are there any systemboard updates (maybe flash the bios) to handle the additional speeds of today's cd-rom devices?

by gigelul

Hi
Try a CD cleaner and check if you have problems with all CDs or only with CDR. How old is the replaced CD-ROM? I saw some bad models which after 6 month or less gave the same problems.

by thechas

Run Belarc Advisor (www.belarc.com) to determine the chipset on the m,otherboard.

Then download and install the latest IDE bus-master driver for the chipset.

You might also try a new IDE cable.

Chas

This discussion is closed to new replies.