Discussion Locked

CD Rom shows as a Hard Drive icon.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a computer with two hard drives and a CD-Rom,one of the hard drives is master and the other is secondary master, the CD-Rom is set as a slave with the master HD, the CD-rom is connected at the end of the IDE cable. When I click my computer icon the CD-Rom shows as a Local HDn it doesn't show the CD-ROM icon, all the jumpers are set correctly, the cables are tight. I wonder if the position of the hard drive and teh cd-rom in the IDE cable matter. Please let me know

5 replies

by dmiles

No,Idon't think it matters how it cable orientation is placed as long as the jumpers are set.
Kind of strange though,check the Device manager to see if the cd-rom is listed in the list of devices
Open the CMOS panel to Bios and on the configuration page,locate the drive setup and see if the cdrom drive is set as slave,if not click on slave drive and then click on auto,this should detect the cd-rom and list it in my computer as the cd-rom drive

by mskiproductions

I dont think this will solve your problem, but do this anyway for some IDE transfer rate improvements.

If you have a CD rom drive on the same IDE channel as a HDD, it will hamper the transfer rates of your HDD. The way IDE controllers work is that both the devices on a single channel will run at the speed of the slowesdt device, and you really dont want your HDD running at the speed of you CD rom drive.

Hve both HDD's on the primary IDE channel (only really makes a difference to have it on the primary if it is UDMA66/100 enabled, but just in case, have them on there anyway). Just make sure the drive with windows on is the Master of that Channel.

If you need more info about IDE configuration, drop me a mail.

Matthew Shine.

Computacenter, Europe.

This discussion is closed to new replies.