Discussion Locked

Cd Rom stopped working!!!

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi! Previously my cd rom was working perfectly well but u see i had to go out of work for a few days and when i came back i saw that the hd has been formatted and windows 98 loaded. ( Previously also win 98) But the cd rom won't take in any disc. The drive has power, is ejecting , the cables are okay, the drive seems okay. But just that it showing in Explorer but not reading any cds. It is giving errors like Device not ready, etc. I think if i format it and reinstall win the problem may be gonebut i do not want to format and wanna know if there is a solution for these and fast.
Thank U
Rajeev

15 replies

by dmiles

Check Device Manager and see if the Controller has a yellow exclamation mark,the drivers may need to be reloaded,update the latest drivers and install the cd-rom software drivers from the manufacturers web site

You can also go to www.bootdisk.comand download the W98 boot disk which will have generic cd-rom drivers

by rajeev418

I said the drive is okay and yes in device driver it is showing everyting okay too. I tried to update the driver as well and it gave me message that the driver is loaded.

by ann777

Boot to safe mode and remove the drivers. Then shutdown and boot normally. See if Windows will detect the device and install.

Probably one or more of the drives are corrupt and reinstalling without removing the drivers, essentially will not overwrite the current corrupt drivers. A fresh install of the drivers is needed and the best way to accomplish that is by booting to safe mode and removing them.

You might also run a scandisk and make sure that your hdd is not going bad.

by rajeev418

the hdd is not going anywhere. also can u tell me exactly what should be the procedure since i do not know how to remove the drivers. I know i can install or upgrade the drivers from device manager. From wher should i upgrade the drivers from? I do not have access to my win 98 cd but do have the win98 folder on my hd. Will that suffice?
Rajeev

by techkid

I think the motor in the cdrom is dead. put in a cd, then put your ear to the cdrom drive. It should always spin up at first to read what type of cdrom has been put in the drive. If you don't hear anything after the cd is initially put in, the motoris dead

by gigelul

Hi,
Make a boot diskette from www.bootdisk.com.
Start the computer with this diskette which contain a CD-ROM driver. If you can acces the CDs from command prompt then the CD-ROM is OK!.
Some CD-ROMs don't support UDMA enabled. Check in BIOS (you must know on which IDE is connected your CD-ROM) and also in Windows (device manager\CD-ROM\properties).
Also check your "autoexec.bat" and "config.sys" files if there is something about CD-ROM. Some DOS driver can conflict with Windows driver.

by thechas

The driver you need, is the IDE bus-master driver for the chipset / motherboard.
If you do not know who's motherboard or chipset is in the system, you can look in device manager, and expand the system branch.

You can also use the BIOS string that appears near the bottom of the screen, and go to either www.motherboards.org
or, www.wimsbios.com
Both sites have tools to help you identify the motherboard MFG, and links to drivers.

Chas

by gigelul

You have here a lot of good answers, but you rejected all.
Why you don't call the tech support which modiffied/reinstalled your system?

This discussion is closed to new replies.