Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Two newer CD-ROMs: Pioneer DVD-ROM(master) and a Philips CD-RW(slave). When a reboot is initiated the two devices are scanned constantly until a hard shutdown is performed. BIOS is at its latest revision.
5 replies
by dmiles
Open the CMOS control anel and set the hard drive as the first boot option
Then chek the jumper setting on the CD-ROM's to make sure one is Master and the other is Slave
You want to try CD-RW as the slave to the primary hard drive and use the DVD as the master or slave on the secondary hard drive,they may not be getting along on the same controller
by jeff.engel
Already attempted...also FYI, the scanning occurs before reaching the BIOS.
by dmiles
Check your anti-virus configuration to check for scan at startup is enabled,this may be the cause of the problem
by jeff.engel
Poster rated this answer
by jeff.engel
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies