Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I HAVE JUST BUILT A NEW SYSTEM 950MHZ WITH 64MB OF MEMORY EVERYTHING WORKS FINE UNTIL I START TO BURN A CD IN THE CD-RW THEN IT SWITCHES IT OVER TO THE LOCAL DRIVE. THE BOX SAYS TO RUN 128MB OF MEMORY FOR THE CD-RW. DO I NEED TO ADD MEMORY TO FINISHBURINING THE CD.
5 replies
by hinrgman
If you want the cd-rw not to switch to the hard drive yes you will need more memory. If you are using the burner and do not want that to happen you will ned at least 256 mb of memory and that will keep it to a minimum
by thechas
64MB of RAM is very low for anything other than Linux or Windows 3.1
If you are running Windows 98, try adding 128MB to your system. Not only will it improve CD writing performance, it will improve overall syatem performance.
If you are running Windows 9X, keep the amount of installed RAM below 511MB to avoid a Windows memory bug.
Chas
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies