Discussion Locked

CD-RW Drive Installation

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I install a CD-RW drive to a system that has a CD-ROM drive? I opened the case but there are so many extra disconnected wires, I don't where to start. Also, step by step diagrams would be helpful.

4 replies

by claycc

Step:
1. Install the drive in your case.

2. locate IDE (primary/secondary) connections on your mother board.

3. If your current hard drive and CD drive are on the same (primary) connection, jumper the new drive as master and connect it to thesecondary connection. Note: the ribbon cable has a collored edge, this goes to pin 1 on the board and on the drive.

4. If the existing hard drive is on the primary connection and the existing CD drive is on the secondary connection, jumper the new drive as a slave and add it to the same cable as the existing CD drive. (beware the ribbon cable in relation to pin 1).
5. Connect the power cable(it only plugs 1 way).

6. Restart system and load drivers as needed.

cable identification:
power cables for CD drives have 4 wires red,black,black and yellow, and have 2 beveled coners to match the receiving outlet on the drive.
ribbin cable will have 1 edge colored (usually red) which is used for pin 1 on the drive and mother board. The cable may only have 2 connectors (1 on each end) this cable is made for 1 drive. To put 2 drives on the same mother board connector (primary/secondary) the cable will have 3 connectors (1 on an end and 2 on the other end for 2 drives)

I hope this helps
Clay

by estebandelatorre

From a good start!
Locate the flat cable connected to the HDD, this cable is connected the "IDE primary" in the motherboard.
Very close to this mother connector should be another connector (equal) which name is "IDE secondary" (both are male connectors)
The cable (itself) may have 2 or 3 female connectors (one about in the middle of the cable)
If a 3 connector cable, it is capable of manage 2 devices connected, one the MASTER (usually the HD) and the other the SLAVE (usually the cdrom).
mother slave master
====================================
ide 1 cdrom hdd

ide 2 free cdrw

This discussion is closed to new replies.