Discussion Locked

CD-RW popping in and out Automagically

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

A client using Win98SE has a recurring problem with a Sony CRX175-A CDRW - 24x 10x 40x burner. The burner tray opens and closes on its own, while the system boots, and even while the system is at rest after starting. This makes the CDRW unusable. I have taken the drive and placed into my own system - no problems - it burnt a cdrom perfectly.

Placed it back into the users system - problem returned. We formatted the system - reinstalled all software and data that had been backed up. The burnerworked for another 3 times, then the problem started again.

Contacted Sony, which is quite willing to replace the unit (it is only 3 mths old) - but I have a feeling this is not really going to help.

Using all current drivers for the motherboard (Soltek - VIA 4in1). I am at my wits end with this one. Any suggestions would be warmly received. Tks in advance.

6 replies

by ann777

You should also check for viruses and trojan horses. Some viruses are known to play with your CD-ROM drive. For a free antivirus service, visit Trend Micro: http://housecall.antivirus.com/

http://www.trendmicro.com/vinfo/virusencyclo/default5.asp?VName=JOKE_PCHAUNT.A&VSect=T

http://www.windowsitsecurity.com/Panda/Index.cfm?FuseAction=Virus&VirusID=56

--------------------------

The following link indicates that it might also be a hardware problem:
http://howto.lycos.com/lycos/step/1,,139+24564+6063,00.html

by ann777

Please remove any embedded spaces in the above links after pasting them in your browser -- and before searching.

by thechas

Check the power supply.
You want a minimum of a 300 Watt supply for a system with a CD-RW drive.

It is possible, that there is a poor connection on the power cable that you are using for the drive, so try a different cable from the power supply.

Also, replace the IDE cable.

You may have an IDE conflict, if neede, install a secondary IDE controller so that the CD-RW drive can be all alone on a seperate IDE channel.

Make sure that DMA mode is set correctly for the IDE channel that the drive is connected to.

Chas

This discussion is closed to new replies.