Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I Had a writabe cd in which already some datas less than 6 MB was written. In the same cd I again wrote some other datas .NOw the problem is when i open the cd, it is showing only either the old data or new data not the both at the same time.That too in some systems it is showing the old data,in some system it is showing newly written data.Can any one help how to see both the datas?
5 replies
by rs_vivek
when I manually see the cd I see there is a small gap between the datas which is written old and the datas which was written newly.
by willcomp
Place CD in PC used to create it and finalize CD.
Dalton
by rs_vivek
But.....
How to finalize the cd...I didnt understand.
by hal 9000
Depending on the CD Recording Software you are using it is generally called Closing the Session.
You burn one file to the CD and chose to close the Session when the current burn is finished.
What would help is to know what you are using to actually burn the CD with Nero, Roxio Easy CD Creator or what?
Col
by rs_vivek
I am using nero burnig rom version 5
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies