Discussion Locked

CDR101: Not Ready Reading Drive D: Why?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hardware Error Message

What should I do to correct this problem?

7 replies

by doug w. mcse nt/2000

1. Bad cd media. Try another.
2. Loose ribbon cable. Re-seat all ribbon connections.
3. Dirty drive or media. Buy a cleaning kit and try again.
4. Bad drive. This is the tough one to swallow!

Good Luck!

by j366oh

Sorry, forgot to mention that this is for a laptop w/ultrabay. But I have a feeling you are correct. It's not a new drive and it's not unheard of to have a bad CD-ROM drive. I did try reseating the drive and cleaning the media without success. Thanks!

by zlitocook

What operating system are you using? Check the cables inside, make sure there compleatly in. Try booting to dos and accessing the cdrom. They can go bad do you have another you can swap and another cable to try? When you boot up watch to see if yourcdrom is detected. Do you have special drivers for your cdrom? They could have become corrupt.

by j366oh

Sorry, I forgot to mention that this is for a laptop w/ultrabay running Windows 98 Second Edition. It actually recognizes the CD ROM drive on boot up but you cannot read any CD's or play an audio CD. I suspect the drive is bad. Thanks anyway!

by mike.wagoner

New problem with a new CD ROM ???? You didn't say if the drive was new. If you haven't gone in and let/told the CMOS that you have a CD, it may have trouble finding it. Also, did you set the CD properly? If you chained it to/with your hard drive, you will need to make sure you set it as a slave. Then do all the other checks that the other two answers suggested.

by j366oh

This is not a new CD ROM drive and it's actually a laptop (570E w/Ultrabay). I suspect that the drive is bad, but thanks anyway!

This discussion is closed to new replies.