Discussion Locked

CDROM DRIVES NOT INSTALLING

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

NEITHER OF MY CD DRIVES BOOT UP OR SHOW UP IN DEVICE MANAGER FILES. UNDER PERFORMANCE TAB I GET THE MESSAGE "DRIVE C--D--E IS USING MS-DOS COMPATIBILITY MODE FILE SYSTEM ETC. ETC.
I CAN'T SEEM TO FIND ANY INFORMATION ON THE ABOVE PROBLEM & WHY MYSYSTEM IS BOOTING UP THIS WAY. ALL HELP WELCOME. THANKS

7 replies

by don christner

There is a know problem with the Intel 82371 chip, go to the Intel site and search for 82371.

Also, go to Microsoft and search for articles Q151911, Q156940 and Q130179.

Loads of fun to fix.

Don

by buffalobobnt

I'M RUNNING AN AMD SYSTEM. YOUR RIGHT THAT IT'S FUN TO FIX. LOOKING AT THE 1900 XP AMD CPU AND END MY PAIN.

by dr. dale

A quick solution is to add the line "lastdrive = z" to your config.sys file. This will allow you to see your cd-rom drives, but it doesn't really address the problem (i.e., "compatibility mode"). I hate to say this, but you probably should reinstall. When you do, copy the cab files to the hard drive, use a 32-bit boot disk, and bypass all the startup files. When Windows Setup finds 16-bit drivers in memory, it defaults to compatibility mode.

by buffalobobnt

DALE, THANKS FOR YOUR HELP. I USED LASTDRIVE=Z WHICH ALLOWED ME TO GET ONE OF MY CDROMS TO WORK, WHICH ALLOWED ME TO REINSTALL WINDOWS 98. THE COMPATABLITY ISSUES HAVE CLEARED UP AND ALLS BACK TO NORMAL. KEEP UP THE GOOD WORK OF HELPING OLDFARTS LIKE ME IN THIS NEW AGE. THIS PROBLEM ALL STARTED AFTER INSTALLING A GEFORCE 3 CARD. BOB

by don christner

It does not matter what Processor you are running, I believe the Intel 82371 controls the IDE bus. So unless all of your drives are SCSI, you may have the 82371.

Don

This discussion is closed to new replies.