Discussion Locked

CDROM FREEZES

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
WHEN I TRY TO LOAD A PROGRAM WITH MY CDROM, THE PROGRAM STARTS UP, BUT WHEN IT STARTS TO LOAD THE PROGRAM,THE SCREEN STALLS AND THE CDROM BEGINS TO SLOW DOWN AND THEN QUITS. I HAVE TRIED TO LOAD FOUR DIFFENENT PROGRAM BUT GET THE SAME RESULTS. MY HARWARE IS A 52X CDROM, MICROSOFT WINDOWS XP HOME EDITION. PENTIUM {R} 4 CPU 1.60 GTZ 224 MB. I HAVE RE-INSTALLED THE DRIVERS FOR THE CDROM BUT STILL THE SMAE PROBLEM OCCURS, ALL HELP WILL BE APPRECIATED

3 replies

by thechas

Some ideas:

Boot into DOS (command prompt) and see if the drive acts normally.
Either browse a CD useing DOS commands, or play an audio CD using the controls on the front of the drive.

If the drive doesn't work, it is defective and needs to be replaced.

From Windows, check device manager (right click my computer and select properties, click on the hardware tab) are there any yellow "?" or "!"? if so, there are hardware / driver problems.

Did the driver for the CD-ROM drive come on a floppy disk?
If so, this is a DOS mode driver, and is not needed for windows at all!
For XP, the DOS driver may actually be the source of your problem.
To un-install a DOS CD-ROM driver, you may need to edit the Autoexec.bat and config.sys files.
You can do this using msconfig from the run box on the start menu.
Just uncheck the boxes for the CD drive files in both system files.
(MSCDEX is one DOS mode CD driver file)

Chas

This discussion is closed to new replies.