Discussion Locked

CDRW error

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an Aptiva Model 2162Q3C. This PC is a split system which means that the Floppy drive and CD-Rom are in a separate console under the Monitor and is joined to the tower through a common cable to the tower on the floor. I have upgraded some items such as a 20.5GB IBM Deskstar 7200rpm HDD which is running as a master on the primary IDE and a CDRW Acer 24x10x40 with Nero v5 software on the secondary IDE which is also a master. I have 64mb of SDRAM and a ZIP 100 drive on my parallel port. WhenI try to do a burn I keep getting an error message "SCSI target error". I did read on the internet a comment which stated that "Guest.exe" which is part of the ZIP software from Iomega sets up a SCSI type of interface for the ZIP drive and the only way to fix this was to wipe the drive and re-install windows, which I did, but the problem still exists. Any suggestions gladly tested as I am running out of ideas other than deserting my Aptiva and building my own version of how a PC should be.

1 reply

by yacco

That console under the monitor is probably the scsi that Nero is erroring on. It scans the busses when it starts and thinks that the burner is in the console. Have you tried to configure the source and target drives in Nero? Do the drive letters show up properly in the selection lists?

This discussion is closed to new replies.