Discussion Locked

CDRW error

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an Aptiva Model 2162Q3C. This PC is a split system which means that the Floppy drive and CD-Rom are in a separate console under the Monitor and is joined to the tower through a common cable to the tower on the floor. I have upgraded some items such as a 20.5GB IBM Deskstar 7200rpm HDD which is running as a master on the primary IDE and a CDRW Acer 24x10x40 with Nero v5 software on the secondary IDE which is also a master. I have 64mb of SDRAM and a ZIP 100 drive on my parallel port. WhenI try to do a burn I keep getting an error message "SCSI target error". I did read on the internet a comment which stated that "Guest.exe" which is part of the ZIP software from Iomega sets up a SCSI type of interface for the ZIP drive and the only way to fix this was to wipe the drive and re-install windows, which I did, but the problem still exists. Any suggestions gladly tested as I am running out of ideas other than deserting my Aptiva and building my own version of how a PC should be.

6 replies

by vorsossion

This may be caused by your operating system. If you are using Windows XP there are ALOT of problems with burning CDs. I would recommend contacting the vendor and asking for any patches or upgrades that are supported by your OS.

If you are on Win98 you can try unplugging the ZIP and rebooting. This will tell you if there is a conflict with your ZIP drive and your CDRW. If there is, you can purchase an IDE expansion card for around $40. It plugs into one of your PCI slots and gives you upto 4 more IDE devices. I would recommend this anyway as sharing an IDE controller slows your system to the slowest device on the controller.

by medicallyinclined

I have re-installed Windows 98 and loaded the ZIP drive software as the last item. I can now run my ZIP and CDRW without any problems. I suspect that either my Modem or Printer drivers were corrupting the ZIP drivers and causing the error.
This is worth noting for future driver errors where the order of installation can sometimes solve the corrupted driver problem once you have identified the hardware involved.

by medicallyinclined

I have re-installed Windows 98 and loaded the ZIP drive software as the last item. I can now run my ZIP and CDRW without any problems. I suspect that either my Modem or Printer drivers were corrupting the ZIP drivers and causing the error.
This is worth noting for future driver errors where the order of installation can sometimes solve the corrupted driver problem once you have identified the hardware involved.

This discussion is closed to new replies.