Discussion Locked

CDRW not performing at peak speed

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just bout an ACER CD ReWriter 10x4x32x. If I try to burn a CD at any speed above 4x, the software returns writing or buffer errors buffer errors. I have tried Easy CD Creator, NeroBurn, and CloneCD but all give me errors unless I use a 4x or below speed. Does anybody know how to correct this?

7 replies

by chattn

It sounds like your 'source' CD is reading faster than you CD-RW and you don't have enough memory to buffer the transfer of data.

Two possible solutions:
1) increase memory
2) copy source disk to HDD and burn from there.

Good luck

by clint hartner

Another possibility occurs to me (besides master source moving more data than you can buffer). Have you checked the media? If you're burning a rewritable disk the speed is bound to the 4X limit (due to limitations in how the data is written). If you're using a CD-R, then I'd check that the media is certified for your max write speed. I haven't personally experienced any media problems, but it is possible.

by dcosgrove

Sounds like buffer under run. CDRs cannot stop recording once they start. If the buffer emtpys, the disk is a coaster. This can be caused by attempting to multitask while burning or even having one of those irritating little tsrs running in the background asking for attention every now and then. Since you are able to burn at slow speeds, I suspect a tsr and not multitasking. Hit ctrl/alt/del and see how many programs are running.

This discussion is closed to new replies.