11 replies
by sgt_shultz
my sympathies. were you petrified or mortar-fied. sorry. don't let this experience make you hard. sorry again.
perhaps you just need to visit the scanner mfg website and download and reinstall the drivers. if you have done that already...
we need more data to help.
model of scanner. like hp 4100
interface type: scsi, parallel or usb?
which version of windows? win98se?
how things are looking in Device Manager. Go to Control Panel and double-click System. Pick Device Manager. do you see anything in there with red or yellow markings on it. if so, tell us what.
by tammye7
Poster rated this answer.
Had already done these things...answered your questions...I hope
by joseph moore
>My computer had crashed when it had filled with concrete mortar
Ok, this is a joke, right??? Did you drop a bag of mortar on the system? Since you "vacuumed" it out, I guess that means that water was not added to the mix!
Well, the lesson about keeping computers away from construction sites aside, let's think about this scanner problem.
What kind of interface does the scanner use, USB or a serial cable? Because maybe the port you plug the scanner into still has some mortar in it, which could prevent the scanner from connecting properly. If that is the case, if these ports are on the motherboard, then you might not be able to clean them out totally, which could mean the scanner will never work unless you get an expansion board, plug it into an available PCI slot (that you will have to make sure is ALSO free of mortar), then try plugging the scanner into and setting it up that way.
Mortar in a computer. I admit, I have never heard of that one!
by tammye7
Poster rated this answer.
Will try cleaning scanner and will look into purchasing an expansion board for computer... hope my addition answers question, a mason tendor in family with nowhere to change makes life difficult...should see hardwood floors...
by oz_media
Are you sure your hardware and chipset isn't damaged?
Depending on the type of mortar you spilled it may have contained a silica base or other additive to assist in creating a heat to set the mortar.
You may have killed a chip or damaged you BIOS.
Have you checked that the BIOS is able to load it's default config?
by tammye7
Poster rated this answer.
Did not spill mortar...BIOS seems to load default config...every thing else loads in fine... Do not think you understood that sig other had mortar dust on clothes. Fan sucked it in to computer.
by thechas
My first concern is that some mortar mix got inside the scanner and onto the drive mechanism.
If so, the scanner may not be initializing when you start it up.
If this is a parallel port scanner, make sure any attached printer is turned on when attempting to access the scanner.
Chas
by tammye7
Poster rated this answer.
Tried that Chas, it is not mortar mix, it is mortar dust as fiance is a mason tendor...he looks like "pig pen" from "Charlie Brown" when he gets home from work. No place to change, did a number on hardwood floors too...
by tammye7
by tammye7
by kathyjp
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending