Discussion Locked

CIH killed my HARD

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Two days ago, my hard was killed by CIH, and I don't know what to do. When I power on my computer I can come in only in BIOS. From floppy I can't boot, because after the main information (CPU speed,RAM capacity and etc.)goes black screen with note: Disk is sick.
There I can't type any commands. In Bios I check that boot up floppy disk is enabled and evrything loks okey here, but I can't still boot up from floppy, the computer don't seek flopp.
What can I do, is there any way to make my hard work again from BIOS.
I know about some programs, but how can I use it if I can't use my floppy disk.

Help me please.

5 replies

by csmith

To gain use of the Floppy Drive, go into the BIOS settings during the POST and tell the PC that
there is no Hard Drive. (Make sure the boot order is set to A,C also.)
The virus gains entry to the memory as soon as the Hard Disk is read, and from that point you
are dead. The BIOS must not read or check the Hard Disk during the boot.
Make sure the floppy is not infected.
I have seen bad write switches that allowed floppies to become infected, so check
everything carefully.
Also make sure you read and follow the instructions at:
www.symantec.com/avcenter/venc/data/cih.html
as mentioned by the first answer to the first posting of this same question.
Regards, Chris

This discussion is closed to new replies.