Discussion Locked

Circuit board swap didn't work can see in bios, but can't see in XP

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Circuit board swap - didn't work, can see in bios, but can't see in XP

I tried a circuitboard swap, exact serial/pn and firmware - but when it boots, it keep trying to access the drive, with that up and down sound. Finally it is seen in the bios, but I get the error :
CAPABLE BUT COMMAND FAILED , hard disk failure press f1 to continue.

I have turned off the SMART monitoring but this didn't work.
It is a Seagate 320 Barracuda ST320620AS

What would you suggest I do next? I tried using EasyRecovery but that didn't recognize the drive either. Is there something in DOS?

Thanks

3 replies

by mjd420nova

This might be a hard drive controler/chip on the control card mounted to the drive itself. If you can buy the same model, swap control cards you might recover the platter data. Maybe NOT. Fault is on the drive not the motherboard. Check your cables or swap to know good set.

by netrate

I have already done the swap - the controller card had a burn mark on it, so I spent quite a bit of time tracking down the same model/firmware number drive from someone on the internet. Got the drive, swapped it and it still doesn't work.

by hal 9000

Again because there is a mechanical fault in the drive or the Mechanical Fault is preventing the drive from working.

Once things have got this bad it's time to send the drive away to your favorite Data Recovery House to have the data recovered which I'm assuming is your idea.

You have now done everything possible to recover the data yourself and it's now time for the professionals to take over if the data is that important. Just be prepared for the costs though as this service doesn't come cheaply when the drive is dead.

Col

This discussion is closed to new replies.