Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Cisco 1000 router will pass Ipx traffic but since a power loss, Ip traffic will not pass on the ethernet side?
3 replies
by rgrowcock
Silly question for you. Did you have the interface setup correctly with a "no shutdown"? Also was the running configuration saved into the startup configuration file? It sounds like the running config had been changed to include IP, but was not saved to the startup config file.
I would check your configuration on that ethernet port first, using "show interface ethernet0". This will tell you what protocols are setup and running. It would be the first step in dxing the problem.
Roger
by dornjim
Poster rated this answer
by dornjim
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies