Discussion Locked

Cisco 2900XL Switch

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My littel brother has delete:

Config file
Flash

I tryed reinstall a new flash file but I keep getting:

switch: copy tftp flash:
tftp: permission denied
switch:

What do I need to do to overcome this problem?

6 replies

by bcbvale

If your flash image has been deleted and you are at the switch: prompt you cannot use the copy tftp flash command to upload a new image. You'll have to use xmodem to upload. Use the following command;

copy xmodem: flash: where is the name of the new image.

When the XMODEM request appears, use the appropriate command on your terminal-emulation software to start the transfer and copy the software image into flash memory.

Be sure to start the XMODEM download within 3 seconds; otherwise, the switch will timeout the XMODEM copy.

After the new image has been loaded, boot the new image using the boot flash: command where is the name of the file that has just been downloaded.

ChrisV

by paulp

Use HyperTerminal to load flash files:

Copy the image to the Flash using HyperTerminal for Microsoft Windows, or another terminal software program. The command on the switch will be copy xmodem: flash: where is the name of file that you downloaded. With HyperTerminal, use the TRANSFER -- SEND FILE option using the XMODEM protocol. Be sure to start the XMODEM download within 3 seconds; otherwise, the switch will timeout the XMODEM copy.

You can read the entire article here:

http://www.cisco.com/en/US/products/hw/switches/ps607/products_tech_note09186a0080094955.shtml

by paulp

Clarification in my response:
delete "file that you downloaded"
and replace with "name of FLASH file"
Sorry about that.

This discussion is closed to new replies.