Discussion Locked

Cisco ACL's & Restricint Websites

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Does anyone know how to restrict a specific website or a range if public IPs from a CISCO router that is connected directly to the web.

5 replies

by lazyvanbee

If you are using a firewall you can set it to stop access to any site or IP address. also you can set up security software to deny access to where ever you want. There is a lot of very good security access software on the market. You do not need to reconfigure the router for this only your own s/ware

by rgrowcock

You would need to configure an acl pointing to that website or the range that you want. The easiest is if it is just a single website with a single IP address. It gets a little harder with a range, because you have to set an mask. The basic command would be:
access-list 100 deny xxx.xxx.xxx.xxx(actual ip) any> access-list 100 permit any. Then apply it to the interface that is directly connected to the web with: int s0>ip access-group 100 in (or out). If I can find a good website that liststhis, I'll add that. Hope it helps. Roger

by danerdo

Thanks for the information. I did find that your answer guided me in the right direction. I had to input some additional information such as:
access-list 121 deny ip xxx.xxx.xxx.xxx 0.0.0.0 any

This discussion is closed to new replies.