Discussion Locked

Cisco Pix firewall and cisco 2600 Router

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi I have Cisco pix Firewall and Cisco 2600 Router and I'm new here. Both r already set up.An IP address is given to it as a Gateway. When I telnet that IP it goes into firewall(the prompt is -pix#).How can I enter into router. and
which command will show me it's over all configuration including all interface setup.

2 replies

by radiic

You have a couple of options. First you could run tracert to that ip gateway ip address and see if you pass through the router, it should show you the ip of the router e0 as you pass through. Then you can try telnet to that ip. The other way to do it is to have a console cable. This is a blue cable with an rj45 end that you plug into the console of the router, and the other end can have a 9-pin end that you plug into a com port. Connect the 9-pin end to a laptop or computer near by. The rj45 end into the console of the router. Then on the computer bring up hyper-term and start a new session, make sure that you change the baud rate to 9600 the rest of the defaults are correct N-8-1. Once you connect press the enter key and you should get a prompt for a password if it is set. Once in you can type "enable", (no quotes) and the password. Then type "show run" it will display the running config of the router. Also a good thing to do is use the capture to text feature of hyper-term and capture your running config to a text file. That way if the config gets blown away, you can always reload the router by pasting the words from the text file into the router.( That has to be done with a console cable)

you could run some othercommands like "show interface" . Also the Cisco IOS command line interface has help built into it. you could type "show ?" and it will list all the show ... commands.

If you need any more help than this, you can feel free to contact me through peer services.

Good Luck
Rad

by tellmewhy

THanx for the help but I can't connect through a console cable for now. I can only do it through telnet. I tried tracert with Gateway IP and it gave me the same gateway IP in just one line and ended without any other line. I'm on NT4 server.
Qs:Isit possible/necessary to give separate IP for pix firewall and the router in the same network? .

This discussion is closed to new replies.