Discussion Locked

Cisco Router can't connect to modem

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a cisco 1600 router and connect to the Internet using leased line.
The modem connected to the router via serial cable through the router.
|And the router is connected to the network switch and all the workstation connect to the internet through the router.
My problem is now the router cannot detect the leased line connection, and it's says that cannot communicate to the modem.
In the configuration iu follow the manual, and before this happend it's all fine.
The modem is ASM-31.
Then i already ask the ISP and ping my modem, then the ISP says they can ping my modem.
In the modem it's all syncronize with the ISP modem and the modem has no problem.
Now the router cannot detect the serial connection.
i connect the modem throushserial0.
In the router console, with "show int serial0" command i can see the info about the router that says,
all up, but line protocol is down and serial0 is down.
I wonder someone can help me out.

Thank you in advanced.

6 replies

by nicholas paras

How can they ping you if the line protocol is down? Check your IP addresses, routes, and connectivity. Try shutting down your interface and then resetting it (no shutdown). Also check that the ISP is doing correct routing to your router.

Hope this helps.

Nicholas
CCNA.

by braveh4rt

Well, i already do that.
I shut down my interface and reset my modem, it can syncronize with the ISP modem or interface. But the problem is in the router, the router can't detect the serial connection . I know it from the "Show int serial0" command to the router. I don't know why.
And i also try to resetting the router. But it's the same.
I also check it with the router software from Cisco. i test the connection between the router and the network. It's ok, but when i test with the leased line through the serial of the router, it says cannot detect the leased line connection.
The line protocol is down, the DCD is down, Serial0 is down. The other is Up.

Any suggestion?

by ridire

The DCD down says this is either a modem config issue or a cabling issue. Mak certain that you are using the correct rs232 serial cable, and if one came with the Cisco router and another with the RAD modem, try both! Also look into baud rate settings for the serial ports of both devices and make certain they are the same on both ends.

Your modem should be an ASM-31/#/V24 , etc. with the V24 being the important part as this specifies the RS232 serial interface type.

I have not found a good command configuration reference for RAD modems on line but you should have documentation, right?

--Paul

by braveh4rt

I already use two serial cable V34, and it's come from cisco. But it still don't work.
And i am lready test the router back to back and it's works fine, with the same cable. But with the modem it can't. Need to know that before this happend, therouter connection to the modem is okay, it can send data.
is it the router configuration mistakes?
And about the baud rate, it's 64 kb leased line and i don't change it since the last time it's connect.
i have try that if i unplug the serial cable frm the rouer, the DCD is up, line protokol and serial0 is down.
What else could be wrong?

This discussion is closed to new replies.