12 replies
by jwilczyn
You can clear CMOS(e.g. password) by shorting pins. To find them, you must look on the board for something as JBAT, Clear Data/Keep Data, CMOS RAM, etc. When you located them - short them, while the system is off.
Removing a battery may help in resetting same data but it's usually for date and time only.
Check:
http://www.computerhope.com/issues/ch000235.htm
http://www.wimsbios.com/
http://www.computerhope.com/network/bios.htm
Good luck
by shanghai sam
by talks2fst
My toshiba laptop has a reset button, a tiny one that you push with a paper clip or something like that. If yours does also, push the reset button with a boot disk in the floppy drive and you will boot to dos... then you can reformat the drive if necessary.
Good luck,
susan
by thinkpink2
by thinkpink2
by gijoe
by thinkpink2
Under the keyboard or bottom of laptop - If you are working on a computer laptop the location of the dipswitch (almost never a jumper) can be under the keyboard or on the bottom of the laptop in a compartment such as the memory compartment.
http://www.computerhope.com/issues/ch000235.htm
Maxwell
by thinkpink2
by gijoe
by thinkpink2
by thinkpink2
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending