Discussion Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just built a box that consists of a MSI K7N2 Delta MB, Athlon XP 2800 Proc, 512MB RAM, 2 80 GB HDD, GEForce FX 5600 Ultra, Fire wire card, etc. When you power the box on the hard drives click (or clunk) 3 times. The machine boots up fine and it never happens again until the machine is warm booted or powered on. The hard drives I am using are Seagate ST380011A 80GB drives. I have hooked each one up individually and together. I also tried a 40GB drive and the same thing happens. I tested all 3 drives in a different computer and they work beautifully. I also tried replacing the IDE cable. It still occurs. Can anyone shed some light?
2 replies
by sgt_shultz
nope. have you looked this up on seagate's site, have you run the seagate diagnostics, maybe looked for drive firmware update? or try hard drives in another box...
by thechas
How big is your power supply?
400 watts is the minimum for your configuration, and I would install a 500 watt to be sure.
I would go so far as to add up the wattages from the rating plate on your supply and verify that the rating is continuous, and not peak power. I have seen a number of power supplies recently that base their rating on the maximum output of all supplies, and do not account for any limits on multiple outputs. Some 300 watt supplies actually have less continuous power output than a good 250 watt supply.
Chas
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies