Discussion Locked

cmos gone

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
problem I'm having with a old computer I bought that had no documentation. Infact I'm not sure of the brand of motherboard. Anyway I installed it in the case and it started up the cmos and such, everything looked good except for a hard drive failure 80. I switched some cables around but could'nt get rid of the message. The mother board does not have very good description on pin# or anything. I tried putting the leads for HD, Power, Speaker, reset, and because they where undetectable I couldn't figure out what went where. Anyway after moving them around in different places I rebooted only to find out I have No startup cmos or anything on the screen at all now. I don't know if I did something that damaged the computer or if I wiped out the cmos. Could anyone help me identify the problem and is there a site that locates bios updates for unknown motherboards? thanks Robert

6 replies

by lordinfidel

If ITeachers does not work, then you will need to reload your BIOS. Which is actually very simple to do.

It sounds like when you moved a jumper you set the "Clear CMOS" jumper. Moving it back will help in this effort.

First though, you will need to find your MB model so you can reset the MB.

Here is a link:
http://www.motherboards.org/moboidtools.html

It's a kick ass site that will help you find your MB type.

You can usually find the model by writing down the String of numbers(the mb ID) when the pc begins to boot. You may have to reboot several times to write down the string. It is usually located in the bottom left of the screen.

Also make a note of what type of BIOS you have (Award etc) This will also help in figuring out your MB.

Look near the BIOS (usually near the battery) and you will see a black flat chipset. Look at the name on the chipset. (it can be something like VIA, Intel etc) That is the MB chipset and is helpful in figuring out the model.

Next, get yourself a DOS bootdisk. You will need it to reload the BIOS.

Look on the site. They should have directions.

Good luck

by pc_kahuna

>>You may have to reboot several times to write down the string.

Instead of doing that, try pressing the "Pause/Break" key when the BIOS string appears. This should hold the machine at that point until the "Esc" key is pressed. This will give youas much time to write down the ID string as you need.

by lordinfidel

I never thought of that.

next time I boot up I will try it.

Makes perfect sense and I have no idea why I never knew/realized this before.

Hmmmmmmm, paint me pink and call me aunt betty.

by mike_step

Try taking all the cables lose from the board. See if the bios come up. Hard drive failure 80 means your hard drive or your cable could be bad, or your hard drive was hooked up wrong. In some computer if the cable is hook up wrong it can keep from booting.

Your motherboard could have a model number on it. If it does you can search the web for information on that model number.

I hope this helps.
Mike,

by o_tudor

All the suggestions I have seen have been excellent, they only thing I would add is this: Why you are inside the case with an older motherboard might as well pop in a new battery for the CMOS as well. It will not help your current situation, but might save you the hassle of doing this again.

This discussion is closed to new replies.