Discussion Locked

com port error message

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I run a program for med billing which has capabilities to file claims electronically.Problem is everytime I try to connect,I receive error message=20,could not open com port3 (lucent win modem is on com port3).It states my hardware settings not correct? I ck'ed device manager-which only shows
com port 1&2. Where is com Port3? I have no other
trouble with my modem because I send data electronically to another computer-different location.Any help would be appreciated.

6 replies

by djent

Assume COM1=irq4 port 378, COM2=irq3 port 278, COM3= irq5 port 3E8, your settings may vary. COM3 is a hardware port for your internal slot mounted or integrated modem, the settings may be adjustable by jumpers, software or chosen from the PCI pool.

by guruofdos

The Lucent Winmodem uses a 'Virtual' Com port and NOT a true hardware com port.

Hardware com ports use base addresses 3F8,2F8,3E8 and 2E8 in that order and share IRQ 4 between Com1 and 3 and IRQ3 between Com2 and Com4. Windows applications using winmodems can map virtual Com3 and Com4 using values in the registry, but it sounds like your comms software only supports 'real' com ports. Look at the resources for the Winmodem in Device manager and I'll lay even money it's using an IRQ and address range that don't match real com port values!

This discussion is closed to new replies.