Discussion Locked

Com Port not communicating

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have installed an internal Conexant Modem. The installation went fine but when trying to access it, I get a message saying that "Can't find the port from the Registry". It is getting very frustrating trying to get the modem to work. Can anybodyhelp?

7 replies

by infra_hdc

It's two reasons:

1. Modem conflicts with com port on your system board. Try to change peripheral settings in CMOS SETUP: disable or set to AUTO one or all of your PC on-board com ports.

2. It's a Win-Modem (PCI). If it's true, then special manufacturer's drivers is required. Refer to your modem vendor, manufacturer or manufacturer's web-site for this.

by renegade99

Open control panel and go into the modems area.
Make sure your modem is listed here. Click on the diagnostics tab at the top of the window and check which com port (if any) your modem is installed on. If it is not listed here try reinstalling the modem drivers. If the modem is listed click on the appropriate com port and click the more info button to see if your computer can communicate with the modem.
You may need to manually change the com port that your modem is installed on(in device manager-Try to set it to Com 1 or 2.) If you get an error msg when clicking on the more info button there may be a physical problem with the modem. Try dialing out using hyperterminal-if it won't dial out here then it would appear that there is an issue with your hardware.

by wizardj

Assuming you have a PnP OS, go to control Panel, System, remove all comm ports and modems. Shut down - power off - power back up and Win99x should find and reinstall all used ports and the new modem.

This discussion is closed to new replies.